Troubleshooting Guide - EINHELL GC-MT 2560 LD Originalbetriebsanleitung

9. Troubleshooting guide

Warning: Switch off the engine and pull out the ignition cable before making any checks or adjustments.
Warning: If, after making an adjustment or repair to the engine, you let it run for a few minutes, remem-
ber that the exhaust and other parts will get hot. Do not touch these parts as these may burn you.
Fault
The unit does not
operate smoothly
and vibrates inten-
sively
The engine does
not start
Engine does not run
smoothly
Drive power falls
The engine will not
start or dies after a
short period of time
The reprinting or reproduction by any other means, in whole or in part, of documentation and papers
accompanying products is permitted only with the express consent of the iSC GmbH.
Subject to technical changes
Anl_GC_MT_2560_LD_SPK9.indb 22 Anl_GC_MT_2560_LD_SPK9.indb 22
GB
Possible causes
- Bolts loose
- Spark plug defective
- Spark plug defective
- Fuel tank empty
- Air fi lter dirty
- Spark plug soiled or defective
- Clutch play too large
- V-belt loose
- Spark plug foul
- No fuel
- 22 -
Remedy
- Check bolts
- Replace spark plug
- Replace spark plug
- Top up fuel
- Clean the air fi lter
- Clean or replace the spark plug
- Adjust clutch cable
- Contact authorized customer ser-
vice
- Clean or replace spark plug
- Top up fuel
22.10.2019 06:24:50 22.10.2019 06:24:50