ABB CP-Serie Betriebs- Und Montageanleitung Seite 16

Type
Electromagnetic compatibility
Interference immunity to
electrostatic discharge
radiated, radio-frequency, electromagnetic field
electrical fast transient / burst
surge
conducted disturbances, inducted by radio-
frequency fields
Interference emission
high-frequency radiated
high-frequency conducted
Additional information relating to UL approvals:
Power, input and output (I/O) wiring must be in accordance with Class I, Div. 2 wiring methods - Article 501-10(B) (1) of the National
Electrical Code.
- SUITABLE FOR USE IN CLASS I, DIVISION 2, GROUPS A, B, C, D OR NON-HAZARDOUS LOCATIONS ONLY.
- WARNING - EXPLOSION HAZARD - SUBSTITUTION OF COMPONENTS MAY IMPAIR SUITABILITY FOR CLASS I, DIVISION 2.
- WARNING - EXPLOSION HAZARD - DO NOT DISCONNECT EQUIPMENT UNLESS POWER HAS BEEN SWITCHED OFF OR
THE AREA IS KNOWN TO BE NON-HAZARDOUS.
When used use in combination with other power supplies than modules ABB series CP-S and CP-C, each input circuitry shall be
provided with overcurrent protection, Circuit breaker - Listed (DIVQ) Type S201 DC-K 6, manufactured by ABB STOTZ-KONTAKT
GmbH. Rated 60 Vdc, 6A
CP-A RU
IEC/EN 61000-6-2
IEC/EN 61000-4-2, Level 3 - air discharge
IEC/EN 61000-4-3, Level 3 (10 V/m)
IEC/EN 61000-4-4, Level 3 ( 2 kV)
IEC/EN 61000-4-5, Level 1 ( 0.5 kV)
IEC/EN 61000-4-6, Level 3 (10 V)
IEC/EN 61000-6-3
IEC/CISPR 22, EN 55022, Class B
IEC/CISPR 22, EN 55022, Class B
CP-A RU
in combination with CP-A CM
8 kV, contact discharge 6 kV
16