Kunzle & Tasin Bona Belt Lite Bedienungsanleitung Seite 16

Prevention Measures for Users (Cont.)
Compliance with safety measures and warnings (cont.)
Using the machine without the safety guards and covers in
position may cause injury or damage. Always ensure that all
safety guards and covers are in position and secured well.
The sanding machine may create an explosive environment.
Cigarettes, cigars, pipes, lighters, pilot flames, or any other
source of fire may create an explosion if lit during sanding
operations. No sources of fire should be kept near the work
area.
Poorly ventilated work areas may create an explosive
environment when some combustible materials are present
in the atmosphere, such as solvents, thinners, alcohol, fuel,
some paints, wood dust or other combustible materials. Floor
sanding may cause various materials and fumes to ignite.
Read the manufacturer's instructions for each chemical
product used and establish its combustibility. Always keep
the work area well-ventilated.
Striking nails when sanding may generate an explosion or fire.
Always ensure all nails are sunk before sanding surfaces.
Serious damage may occur if the power supply circuit trips
repeatedly or is undersized. Have the fuses, safety circuit and
power supply line checked by an authorized electrician.
Performing maintenance and/or repairing the machine when
it is not fully disconnected from the power supply may cause
death due to electrocution. Disconnect the power supply
before carrying out any maintenance and/or repair work.
16 16
The use of this machine on a circuit which is not grounded
may cause death due to electrocution. Never disconnect or
disable the grounding conductor. Consult an electrician if the
ground conductor is missing or it is suspected that the circuit
is not suitably grounded.
The use of this machine with a damaged power supply cable
may cause electric shock. Check the power supply cable
regularly for damage such as splitting or wear and tear. DO
NOT use the machine if the power supply cable is damaged.
DO NOT use the electric cable to move the machine.
Injury or damage may occur if the machine runs over the
power supply cable and it becomes damaged. Keep the cable
away from the lower part of the machine to avoid contact
with the abrasive. Always keep the power supply cable raised
above the machine.
The moving parts on this machine may cause serious injury
and/or damage. Keep hands, feet and loose clothing away
from all moving parts of the machine.
Performing maintenance or replacing the dust bag may cause
injury to the operator or people nearby if the machine is
connected to the power supply.
Bona Belt Lite Manual