Instructions For Electrical Connection - Kunzle & Tasin Bona Belt Lite Bedienungsanleitung

Commencing Operation (Cont.)
Instructions for assembly following transportation (cont.)
6.
Fit the suction pipe (A) and drum control rod (b).
7.
Lift the drum with the lever (A).

Instructions for electrical connection

This machine only operates
with the voltage and
frequency shown on the
machine data plate. Before
connecting the cable to
the power supply ensure
the correct voltage and
frequency are available.
8.
Connect the power supply cable
to the machine and
power supply.
DO NOT expose the machine to rain. This machine is intended
for dry use only. Keep the machine in a dry building and DO
NOT use it in damp or wet places.
If the machine is not connected correctly to the electricity
network, death due to electrocution may occur. To prevent
electric shocks always use a grounded three wire electrical
system. For maximum protection against electric shocks use a
circuit protected with a differential cut-out switch.
Tampering with the grounding plug in any way may result in
death from electrocution. DO NOT cut, remove or break the
grounding plug. If the socket does not match the plug consult
a qualified electrician.
Do not use the machine if the switch malfunctions.
Bona Belt Lite Manual
If the machine is used with
a damaged plug or power
supply cable, death may
occur from electrocution.
If cables or plugs are worn
or damaged in any way,
have them replaced by the
manufacturer or certified
machine repair center in
order to prevent risks to
safety.
13 13
EN