Geberit SIGMA10 Bedienungsanleitung Seite 14

EN
1
Remove the actuator plate.
To ensure that the conversion is
successful, the following steps must
be performed within 15 minutes:
2
Disconnect the power supply cable
from the control for 10 seconds.
14
3
Reconnect the mains cable to the
control.
✓ Indicator light lights up.
4
Place your hand at a distance of 2–
3 cm away from the sensor.
✓ A flushing process is activated.
✓ After approximately 20 seconds,
5 triple tones sound to indicate
acoustically that deactivation is
complete.
5
Move your hand away.
9007203698350091-1 © 07-2019
966.230.00.0(03)