Herunterladen Diese Seite drucken

Axor Starck 10123003 Gebrauchsanleitung, Montageanleitung Seite 2

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

EN
0 2
S A F E T Y N O T E S
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
The hot and cold supplies must be of equal pressures.
I N S T A L L A T I O N I N S T R U C T I O N S
⁄ Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
⁄ The pipes and the fixture must be installed, flushed and
tested as per the applicable standards.
⁄ The plumbing codes applicable in the respective coun-
tries must be observed.
⁄ The drain valve must only be used as intended. It is not
allowed to attach other objects to the drain valve, for
example a semi-pedestal.
⁄ If the instantaneous water heater causes problems or
if you wish to increase the water flow, the EcoSmart
(flow limiter) located behind the aerator can be
removed.
T E C H N I C A L D A T A
This mixer series-produced with EcoSmart
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
The product is exclusively designed for drinking water!
A S S E M B L Y (see page 04)
S Y M B O L D E S C R I P T I O N
®
(flow limiter)
®
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
max. 70°C
65°C
max. 70°C ⁄ 4 min
Do not use silicone containing acetic acid!
D I M E N S I O N S (see page 06)
F L O W D I A G R A M (see page 06)
 with EcoSmart
®
 without EcoSmart
®
S P A R E P A R T S (see page 07)
O P E R A T I O N (see page 05)
Hansgrohe recommends not to use as drinking
water the first half liter of water drawn in the
morning or after a prolonged period of non-use.
C L E A N I N G (see page 05)
T E S T C E R T I F I C A T E (see page )

Werbung

loading

Diese Anleitung auch für:

Starck 10111003