Honeywell EH-610E Gebrauchsanweisung Seite 7

TROUBLE SHOOTING
Problem
The Power Switch (13) is
set to position (I) or
The Night Light (14) does
not illuminate.
The humidifier only produces
little or no mist.
The Reset Light (15)
illuminates.
Water overflows from
Water tank.
Condensation forms around
the humidifier or windows.
CONDITION OF SALE
As a condition of sale, the purchaser assumes
responsibility for the proper use and care of this
appliance in accordance with these printed
instructions. The purchaser or user must judge
himself or herself when to use the appliance and
the length of use.
Possible Cause
1. The plug is not plugged in.
(II) . There is no power at the
2.
outlet.
No water in Tank (6).
1.
The unit is not placed on a
2.
firm, level surface.
Mineral deposits on
3.
Heating element (16) or on
Removable Water Tray (4).
The Water Tank (6) was
4.
washed with a washing
liquid and
thoroughly.
No water in Tank (6).
1.
After refill, the humidifier
2.
was not taken into operati
on as described under
"RESET-Instructions"
The Water Tank (6) may
1.
Be damaged.
The Tank Cap (8) is
2.
leaking.
The relative humidity in the
1.
room is too high.
ENGLISH
not rinsed
.
NOTE: IF YOU EXPERIENCE A PROBLEM
WITH YOUR HUMIDIFIER PLEASE SEE
WARRANTY FOR INSTRUCTIONS. PLEASE
DO NOT ATTEMPT TO REPAIR THE
HUMIDIFIER YOURSELF. DOING SO WILL
VOID THE WARRANTY AND COULD
CAUSE DAMAGE OR PERSONAL INJURY.
Technical specifications are subject to change.
7
Solution
1. Plug the humidifier in.
Check the circuits and
2.
fuses or ask a specialist.
Fill the Water Tank (6).
1.
Place the humidifier on a
2.
firm, level surface.
Clean or disinfect the
3.
Heating Element (16) and
the Removable Water
Tray (4).
Empty the water and rinse
4.
thoroughly with warm
water.
Fill the Water Tank (6).
1.
Follow the
2. „RESET-
.
Instructions"
Check the Water Tank (6)
1.
for leaks and replace it if
necessary.
Check the Tank Cap (8)
2.
and tighten by turning it
clockwise.
1. Follow the "Operating
from figure 6.
Instructions"