Transport; Pulling Or Pushing The Garden; Environmental Protection; Standard Spare Parts - Viking GE 355 Gebrauchsanleitung

12. Transport

Risk of injury:
Before transporting, carefully read
and observe the section "For your
safety", in particular the
"Transporting the machine" section.
( 4.4)
Only transport the garden shredder
with the chute fitted. Before lifting
the machine, note the weight given
in the "Technical specifications"
section. ( 18.)
12.1 Pulling or pushing the
garden shredder
● Hold the garden shredder at the
upper chute (1) and tilt to the rear.
● The garden shredder can be pulled or
pushed slowly (walking pace).
12.2 Lifting or carrying the
garden shredder
At least two persons are always
required to lift and carry the
machine.
Wear suitable protective clothing;
the lower arms and upper part of
the body must be fully covered.
● 1. First person: Hold the garden
shredder at the handles on the upper
chute (1).
● 2. Second person: Hold the garden
shredder at the bar of the ejection chute
extension (2).
50
● Lift the garden shredder
simultaneously.
12.3 Transporting the garden
shredder on a load floor
● Secure the machine against
slipping using suitable fastening
materials. Attach ropes or straps to the
wheel carrier (1) or the feed chute (2).

13. Environmental protection

Shredding material should be
composted and not disposed of
21
in household waste.
The machine, its packaging and
accessories are all produced
from recyclable materials and must be
disposed of accordingly.
By disposing of materials separately, and
in an environmentally friendly manner,
valuable resources can be re-used. For
22
this reason, the machine should be
disposed of for recycling at the end of its
useful life.
13.1 Disposal
Render the machine unusable prior to
disposal.
In particular, remove the power cable and
electric cable to the motor for this purpose.
Risk of injury from the blades.
Always store an old garden shredder in a
safe place prior to scrapping. Make sure
that the machine and the blades are kept
out of the reach of children.
23

14. Standard spare parts

Blade disc assembly
6011 700 5100
Combination blade
6011 702 5100
Wing blade 1
6011 702 0300
Wing blade 2
6011 702 0310
Wing blade 3
6011 702 0320
Set of shredding blades
6011 007 1000

15. Circuit diagram

GE 355
1
Mains connection
24
0478 201 9907 D - EN