Checking Installation - Siemens Gigaset USB 54 Kurzbedienungsanleitung

Gigaset USB Adapter 54 / english / A31008-E505-B104-1-PED1 / eng_usb54.fm / 12.03.2004
english

Checking installation

If installation was successful, you can now use the Gigaset WLAN Adapter Monitor. With
the Gigaset WLAN Adapter Monitor you can configure your Gigaset USB Adapter 54 and
create a connection to other network adapters or an Access Point.
The Gigaset WLAN Adapter Monitor is represented by an icon in the status area of the
taskbar, this icon also shows you if there is already a connection to a connection partner.
The following may be displayed in the status area of the taskbar:
ü
During an active connection, the number of coloured bars in the icon indicates the
connection quality, the more bars shown the better the quality of the connection:
16
No icon:
Software not launched
First try to open the Gigaset WLAN Adapter Monitor
manually.
ì
In the start menu, click on Start > Programs >
Gigaset USB Adapter 54> Gigaset WLAN Adapter
Monitor.
If this fails, then something went wrong during installation.
ì
Deinstall the software.
ì
Then install the software again.
Software available, red ball above the icon:
Gigaset USB Adapter 54 not plugged in
ì
Check the USB connection.
Red cross above the icon:
No connection to the network
ì
Configure the Gigaset USB Adapter 54.
The detailed instructions on the CD-ROM
supplied will tell you how to do this.
Green ball above the icon:
Connection established
The number of bars in the icon depends on the connection
quality (see below).