Fellowes Powershred M-8C Handbuch Seite 3

BASIC SHREDDING OPERATION
PAPER/CARD
1
Continuous operation:
Set to Auto-On (
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
5 minutes will trigger a
30-minute cool down period.
PRODUCT MAINTENANCE
OILING SHREDDER
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
noise when shredding and could ultimately
recommend you oil your shredder each time
you empty your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature
time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder.
PAPER JAM
1 2
Set to Reverse Alternate slowly back and forth
( ) for
2-3 seconds
LIMITED PRODUCT WARRANTY
defects in material and workmanship and provides service and support for 2 years from the date of
from defects in material and workmanship for 3 years from the date of purchase by the original
consumer. If any part is found to be defective during the warranty period, your sole and exclusive
warranty does not apply in cases of abuse, mishandling, failure to comply with product usage
standards, shredder operation using an improper power supply (other than listed on the label), or service under this warranty, please contact us or your dealer.
3
2
)
When finished shredding
straight into paper
entry and release
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1 2
Set to Off ( ) * Apply oil
3 4
Set to Off ( )
and unplug
)
) position, then slide black button down.
3
Set to Reverse ( )
for 2-3 seconds
across entry
5 6
Gently pull uncut Set to Auto-On (
paper from paper and resume shredding
entry. Plug in.
)
3