Operation; Switching On And Off; Squelch Adjustment - Omnitronic UHF-440 Bedienungsanleitung

■ During charging, the LED indicator for the corresponding compartment will light up.
■ Charging is completed, when the LED indicator of the charging compartment goes off. You can remove the
microphone from the charging compartment.
■ If possible, always use the entire capacity of the battery. Short discharging/recharging cycles will reduce
the battery's capacity.
■ The battery charging status is indicated on the microphone's LCD screen:

7. OPERATION

7. Receiver

7.1.1 Switching on and off

■ Switch on the receiver with the POWER switch. The display of the respective receiving unit indicates the
transmission channel or the frequency adjusted last.
■ After operation, switch off the receiver with the power switch.
7.1.2 Settings in the main menu
■ While the receiver is turned on, press the SET button to enter the main menu which allows for adjusting the
following settings: squelch (
volume ( ), display (
VOLUME
Press the SET button repeatedly to cycle through the main menu. The settings and values can be adjusted
with buttons ▲ and ▼ (the display indication is flashing). Confirm your settings with the SET button.
■ The display can indicate the transmission channel or the frequency (the factory setting is transmission
channel). To change the current setting, press the SET button repeatedly until the display indicates
„ ". Use buttons ▲ and ▼ to select „
DISPL
settings with the SET button.
7.1.3 Channel and frequency adjustment
■ Prior to switching on one of the microphones, first set each receiving unit to a free transmission channel and
frequency.
■ Press the SET button repeatedly until the display indicates „
and ▼. Confirm your settings with the SET button. The transmission frequency can be set in menu „
Also use buttons ▲ and ▼ and confirm with the SET button.

7.1.4 Squelch adjustment

■ The threshold value for the response of the squelch can be adjusted between 0-30 in the menu
with 0 being lowest and 30 the highest setting. The squelch will mute the receiver if during music intervals
If the battery symbol extinguishes and the LCD screen starts flashing, the
rechargeable battery is going flat and the microphone switches off automatically
within a short time.
If a bar inside the battery symbol is displayed, the battery is presently being
charged.
If all four bars in the battery symbol are displayed, the battery is fully loaded and
charging is completed.
), transmission channel (
SQUELC
), lock mode (
DISPL
CHANNE
), transmission frequency (
CHANE
).
LOC
" (channel) or „
FREQUE
". Adjust the channel with buttons ▲
CHANNE
21/24
TUNE
" (frequency). Confirm your
TUNE
SQUELC
00031676.DOC, Version 1.1
),
".