Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
high-frequency interference signals are received of which the level is below the threshold value adjusted.
With a longer distance between microphone and receiver, a lower value should be selected. With a shorter
distance, a higher value is applicable.
■
Press the SET button repeatedly until the display indicates „
and ▼. Confirm your settings with the SET button.
7.1.5 Volume adjustment
■
The volume output of the receiver can be adjusted between 0-37 in the menu
lowest and 37 the highest setting.
■
Press the SET button repeatedly until the display indicates „
and ▼. Confirm your settings with the SET button.
7.1.5 Lock mode
■
To prevent accidental change of settings in the main menu, it is possible to activate the lock mode.
■
Press the SET button repeatedly until the display indicates „
(lock mode active) or „
OFF
7.2 Microphones
7.2.1 Switching on and off
■
After adjusting the receiver, keep the On/Off button of the microphone pressed for approx. 2 seconds to
switch it on. The display indicates „
the RF level, the sensitivity and the battery charging status.
■
To switch off the microphone, keep the On/Off button pressed for approx. 2 seconds until the display
indicates „
".
OFF
7.2.2 Settings in the main menu
■
While the microphone is turned on, press the SET button to enter the main menu which allows for adjusting
the following settings: transmission channel (
sensitivity (
), lock mode (
SENSIT
Press the SET button repeatedly to cycle through the main menu. While the display indication is flashing,
the settings and values can be adjusted with buttons ▲ and ▼. Confirm your settings with the SET button.
■
The display can indicate the transmission channel or the frequency. To change the current setting, press
the SET button repeatedly until the display flashes and indicates „
„
" (channel) or „
CHAN
FREQ
7.2.3 Channel and frequency adjustment
■
Set each microphone to the transmission channel and frequency of the respective receiving unit.
■
For adjusting the transmission channel, activate the main menu with the SET button. The channel
indication „
" on the display starts flashing. The display keeps flashing for approx. 10 seconds. During that
CH
time, the channel can be adjusted with buttons ▲ and ▼. Confirm your settings with the SET button.
Afterwards, adjust the transmission frequency. Also use buttons ▲ and ▼ and confirm with the SET button.
" (lock mode deactivated). Confirm your settings with the SET button.
" followed by the transmission channel or the frequency adjusted last,
ON
CH
).
LOC
" (frequency). Confirm your settings with the SET button.
". Adjust the value with buttons ▲
SQUELC
". Adjust the value with buttons ▲
VOLUME
". Use buttons ▲ and ▼ to select „
LOC
), transmission frequency (
". Use buttons ▲ and ▼ to select
DISPL
22/24
with 0 being the
VOLUME
), display (
MHz
DISPL
00031676.DOC, Version 1.1
"
ON
),
Werbung
Inhaltsverzeichnis
