Klarstein Steam bro Bedienungsanleitung Seite 26

EN
26
In addition to conventional steam-ironing, the iron can also emit a strong blast of steam,
e.g. for smoothing stubborn creases or textiles which are hanging up.
1. Make sure that the water reservoir has been fi lled and the device has heated up.
2. Press the button for a steam blast (12)
front of or on the fabric and then release the button again. NOTE: When performing
vertical steam-ironing on delicate fabrics, hold the iron a few centimetres away from
the fabric.
3. Wait a few seconds before you press the button again.
Spray Function
The spray function is suitable, for example, for moistening delicate textiles which cannot
be steam-ironed. This function is independent of the steam function and is possible at
any temperature.
• Make sure that the water reservoir has been fi lled. Press the
a few times. Water will be sprayed through the spray nozzle (9) onto the fabric.
NOTE: This function is independent of the steam function and is possible at any
temperature.
After Use
1. Once you have fi nished ironing, switch off the steam function and the temperature
control (5) to position MIN.
2. Place the device upright on the base (2).
3. Remove the mains plug from the plug socket.
4. Allow the bottom (6) of the iron to cool down completely.
5. Empty the water reservoir (7). To do this, fl ip open the water reservoir cover (10),
hold the iron over a sink or similar outlet and turn it upside down. Allow all of the
water to fl ow out of the reservoir (7).
6. Then connect the iron to the mains power, switch on the steam function and move
temperature control to the maximum setting (7) for a couple of minutes so that the
rest of the water evaporates. Hold the iron horizontal as you do this. Then repeat
steps 1 to 4.
7. If necessary, wipe down the outside of the device with a soft, slightly damp cloth
and then dry it with a soft cloth.
move the bot- tom of the iron (6) a little in
spray button (1 1)