Installing The Ventilation Kit Before Positioning The Stove; Installing The Ventilation Kit After Installing The Stove And Surround; Cooling The Fan - Piazzetta MULTIFUOCO 2003 Einbau- Und Bedeienungsanleitung

2. INSTALLING THE VENTILATION KIT BEFORE
Proceed as follows:
ensure that there is an electric power socket near the stove.
Remove the nuts from the screws on the fan flange; put the fan in the lower part of the stove and fix the whole
assembly using the nuts and washers that have just been removed. In the 400, 500, 510, 555, 650, 2010
models, the screws for fixing the ventilation kit are to be found in the lower part of the stove: prepare the fan by
removing the screws and nuts and fix it to the stove, inserting the vibration-isolation mountings between the
two components and using one of the screws to fasten the eyelet terminal of the yellow-green earth wire.
Unscrew the wing nut from probe-holder bracket located on the
bottom of the stove, insert the bulb of the PT probe about 30 cm
into the probe-holder tube in the rear part of the flue, fasten the
probe to the bracket and tighten all the screws and nuts; in
model 510, put the probe into the space between the fan flange
and the bottom of the stove.
If the product is fitted with two motors (e.g. mod. 600) this
step must be repeated.
Insert the radio-control box plug into the 220V socket already
provided.
Connect the fan to the hot air outlets through hoses. The fan is
fitted with one Y-element, but the line can be split up by using
two Y-elements thereby making it possible to connect up with
four outlets.
If you also wish to send hot air to adjacent rooms, choose the
shortest route, thus limiting loss of heat. It is advisable to avoid
running the hoses along very long routes, and to insulate them
properly. (See instructions enclosed with stove).
Gruppo Piazzetta S.p.A. supplies ø75 hoses, air outlet nozzles, Y-
elements and hose clamps for assembly, on request.
N.B. It is advisable to keep the radio-control box away from heat
sources, such as hot air ducts or mechanical parts which tend to get
hot.
3. INSTALLING THE VENTILATION KIT AFTER
INSTALLING THE STOVE AND SURROUND
Proceed as follows:
remove the grate and the ash drawer, loosen the fixing screws with a screwdriver and remove the lower guard.
Then proceed as described above.
4. COOLING THE FAN AND THE RADIO-
The fan is cooled by the external air intake when the latter is positioned behind or under the stove. In the absence
of an air intake, cooling is assured by environmental air, so an opening of at least 120 cm² in the lower part of the
surround must be provided.
26
POSITIONING THE STOVE
CONTROL BOX