Cleaning And Maintenance - FUST PRIMOTECQ TW 730 E Benutzerinformation

54
If you open and then close the door
before turning the selector dial to
the lights corresponding to the phases
making up the performed programme
come on.

CLEANING AND MAINTENANCE

Emptying the water reservoir
Empty the water reservoir after every drying
cycle.
Caution! The condensed water is not
suitable for drinking or for preparing
foodstuffs.
If the programme has been interrupted
as a result of the water reservoir being
full: Press the START/PAUSE button to
continue the drying cycle.
Cleaning fluff filters
The filters collect all the fluff which accumu-
lates during drying. To ensure that the dryer
works perfectly, the fluff filters (micro-fine fil-
ter and fine strainer) must be cleaned after
every drying cycle.
After each use
all
• Clean the filters.
• Empty the water reservoir.
Caution! Never operate the dryer
without fluff filters or with damaged or
blocked fluff filters.
Cleaning heat exchanger filters
The heat exchanger fluff filters in the base
of the appliance must be cleaned, i.e. after
each 3 drying cycles. Both filters are loca-
ted in the appliance base. Water can collect
in the filter housing therefore it is normal for
the heat exchanger fluff filters to become
wet.
• Never operate the dryer without the fluff
filters.
• Clogged filters cause higher energy con-
sumption (drying cycle elongation) and
dryer damage.
• A dirty heat pump can only be cleaned
up by means of a costly process.