Preparing The Remote Controller - DJI Datalink 3 Kurzanleitung

3. Linking
Example: DJI N3 Flight Controller.
a. First, insert the Air System antenna extension cables into the ports on the side of
the Air System and snap them into place. Then connect the Air System antennas
to the antenna extension cables.
b. Connect the DBUS/SBUS port on the Air System with the RF port on the DJI flight
controller series using the provided DBUS cable.
c. Power on the remote controller and press the C1, C2 and D buttons simultaneously.
The Status LED will blink blue and make a warning sound, indicating that linking
has started.
d. Press the Linking Button on Air System. Status LEDs on both the remote controller
and the Air System will turn solid green when linking is complete.
Refer to Datalink 3 User Manual for more linking methods.

4. Preparing the Remote Controller

Strong
5. Flight
DJI series flight controllers have a default flight mode is known as Mode 2. The
left stick controls the aircraft's altitude and heading, while the right stick controls
forward, backward, leftward and rightward movements.
Left Stick
Unfold the remote
controller
Weak
Press the clamp on the mobile
device holder.
Adjust the clamp to secure the
mobile device.
Connect the mobile device and the
remote controller with a Micro USB
cable.
Right Stick
5