Downloading The App; Battery Level And Charging - DJI Datalink 3 Kurzanleitung

Air System
1
2
3
1. Firmware Update Port (Micro USB)
2. CAN Port
3. UART Port
4. Status LED
When using the DBUS cable to connect the flight controller and the Air System, no extra power
supply is needed. DO NOT use the power port on the Air System for power supply; However, it
is essential to provide extra power supply (8-30 V) when using the SBUS cable to connect the
flight controller and the Air System.
Ensure there is enough space between the Air System and other structures to avoid triggering
the linking system during flight.
Select the receiver type in DJI ASSISTANT™ 2 after connecting the aircraft and the Air System
when using the DJI series flight controllers. Not doing so may lead to serious flight hazards

1. Downloading the App

Scan* the QR code below or visit the App Store to download DJI's MG or GS Pro apps.
* DJI MG app currently only supports some mobile devices with Android 5.0 or above. Refer to
"Specification" in Datalink 3 User Manual for more details. GS Pro is only supported on iPad with
iOS 9.2 or later.
2.

Battery Level and Charging

Press the power button once to check
the battery level. Press and hold for
2 seconds to power on the remote
controller.
Please use the included charger to charge the remote controller, when the power
level is low. It is recommended to charge the remote controller with the power off.
Please recharge the battery at least every three months to prevent over discharging
– the battery will deplete when stored for long periods.
4
4
6
5
MG App
It takes about 4 hours to fully charge the remote controller.
8
7
5. Linking Button
6. Antenna Ports
7. Power Port
8. DBUS/SBUS Port
GS Pro App
Low Battery High
100~240 V
(50 Hz/60 Hz)