Functional Description; Operation - Makita AT450H Bedienungsanleitung

FUNCTIONAL DESCRIPTION

CAUTION:
Always disconnect the hose before adjusting or
•
checking function on the tool.
Adjusting depth of stapling
CAUTION:
Always disconnect the hose before adjusting the
•
depth of stapling.
Fig.5
Fig.6
If a staple is driven too deep, turn the adjuster clockwise.
If a staple is driven too shallow, turn the adjuster
counterclockwise.
The adjustable range is 0 - 3 mm. (One full turn allows
0.8 mm adjustment.)
Hook
CAUTION:
Always disconnect the hose when hanging the tool
•
using the hook.
Never hang the tool on a waist belt or like.
•
Dangerous accidental firing may result.
Fig.7
The hook is convenient for hanging the tool temporarily.
The hook position can be changed.
When changing the installation position, remove the
screw with a screwdriver. Install the hook in desired
position and then secure it with the screw.
Flat nose adapter
CAUTION:
Always disconnect the hose before installing or
•
removing the flat nose adapter.
Fig.8
Before stapling on flat surface of workpiece, attach the
flat nose adapter to the contact element.
To attach the nose adapter to the contact element,
press it onto the contact element until the protrusion
inside the nose adapter fits the groove in the contact
element.
ASSEMBLY
CAUTION:
Always disconnect the hose before carrying out
•
any work on the tool.
Loading stapler
CAUTION:
Always disconnect the hose before loading the
•
tool or removing staples.
Do not use deformed staples or staple strip.
•
Failure to do so causes poor staple feeding.
Always use staples specified in this instruction
•
manual. Failure to do so causes poor staple
feeding.
Always return the pusher slowly and gently while
•
holding it with a hand.
Returning the pusher base with the pusher being
•
pressed does not allows staples to be loaded. Do
not press the pusher when loading.
Fig.9
Insert a strip of staples into the slit in the rear of the
magazine until it overpasses the staple stopper. The
tool accepts a strip of staples (84 pcs.)
Fig.10
Pull the pusher base all the way to the rear of the
magazine and return it slowly and gently to the original
position..
Removing staples
Fig.11
Hold the tool that the rear of magazine faces downward.
Pull the pusher base slightly, press the pusher from both
sides and release the staples. Return the pusher base
gently and slowly.
Press the staple stopper and then take out the staples
from the back of magazine.
Connecting air hose
Slip the air socket of the air hose onto the air fitting on
the stapler. Be sure that the air socket locks firmly into
position when installed onto the air fitting. A hose
coupling must be installed on or near the tool in such a
way that the pressure reservoir will discharge at the
time the air supply coupling is disconnected.

OPERATION

CAUTION:
Make sure all safety systems are in working order
•
before operation.
1. To drive a staple, you may place the contact
element against the workpiece and pull the trigger,
or
Fig.12
8