Specifications - Makita AT450H Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Contact element
1-2. Trigger
2-1. Contact element
2-2. Trigger
2-3. Workpiece
5-1. Adjuster
5-2. Deep
5-3. Shallow
6-1. Too deep
6-2. Flush
6-3. Too shallow
7-1. Screw
7-2. Hook

SPECIFICATIONS

Applicable staples
Min. hose diameter
Pneumatic tool oil
Dimensions (L x W x H)
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
Wear safety glasses.
･
Do not use on scaffoldings, ladders.
Intended use
The tool is intended for pressing staples into
construction materials such as timbers.
Noise
The typical A-weighted
according to EN792:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
Explanation of general view
8-1. Groove
8-2. Protrusion
8-3. Contact element
8-4. Flat nose adapter
9-1. Staple stopper
9-2. Pusher base
10-1. Pusher base
11-1. Pusher
11-2. Staple stopper
11-3. Pusher base
12-1. Trigger
12-2. Contact element
13-1. Trigger
Model
Air pressure
Staple capacity
Net weight
noise level determined
) : 80 dB(A)
pA
END106-3
Vibration
The vibration total value determined according to
EN792:
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
ENE054-1
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
ENG905-1
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
4
13-2. Contact element
14-1. Trigger
14-2. Change lever
15-1. Trigger
15-2. Change lever
17-1. Exhaust cover
17-2. Exhaust vent
18-1. Hex wrench
19-1. Front guide
19-2. Contact top
22-1. Drain cock
AT450H
1.28 - 2.26 MPa (12.8 - 22.6 bar)
25 mm - 50 mm
84 pcs. (1 strip), max. 105 pcs.
5.0 mm
ISO VG32 or equivalent
261 mm X 115 mm X 269 mm
1.5kg
) : 2.5 m/s
h
2
ENG904-2
2
ENG901-1