Installation Of Backrest; Activation Of The Remote Control - Topro Modena Betriebsanleitung

TRANSPORT & INSTALATION
1
2
4
Chart 7: Installation of backrest
1
2
Chart 8: Activation of the remote control
50
3

5.2.2 Installation of backrest

In case the dealer didn't fully set the chair up for you,
proceed as follows:
1. Your chair consists of two pieces: A back- and a
sitting piece which have to be connected (1.).
2. Slide the backrest (2.) on the seat and make sure
the two mounting plates (3.) of the chair slide into
the mounting spots of the backrest.
3. Put some pressure on the backrest to lock the
mounting brackets in (4.).
HINT!
Check screws regularly and
tighten if loose.
WARNING!
Risk of impact and crushing during
the installation of backrest.

5 2 3 Activation of the remote control

The remote control is equipped with a safety pin to
prevent accidents. To use the remote control do as
follows:
1. Insert the safety pin (1.) into the left side of the
remote control (2.). The chair is now activated and
ready to be used.
HINT!
If the chair is not used, please
remove the safety pin to prevent
accidental activation of the motor,
e.g. by children or pets.