Diamond INNOVA 500 GBT Zusammenbau Und Betrieb Seite 8

6. CONTROLS
The controls of the appliance are situated at the front inside a protected recess.
turning on the light inside the appliance.
3. Thermometer for reading the temperature in the appliance.
the appliance: a) press key
be changed by pressing key
7. CHECKING CORRECT OPERATION
Make sure that: 1. the plug is connected; . the refrigeration unit switch is turned on (green light lit up);
3 . thermometer shows the desired temperature for the goods to be stored; . rotation system and lights
are turned on; . door is firmly closed; . appliance is not exposed to direct sunlight or to powerful lamps; 5
7 . ambient temperature does not exceed +30°C with 55% R.H. (climatic class 4);
ventilation for the motor compartment; there is a clearance of at least 30 cm in front of the grill; . the
cabinet is suitably filled and shelves are not overloaded (max. 6 kg per shelf); there are sufficient gaps
inside the cabinet to enable cold air to circulate, especially between the rear glass panel and the shelves
in the area near the air outlets.
8. INTERNAL CLEANING (EVERY 15 DAYS)
1 . Switch off the appliance.
the door open and defrost the appliance completely.
bottom of the display cabinet.
evaporator. 6. Dry everything with care.
restarting (see figure 6).
9. REPLACEMENT OF INTERNAL LIGHT BULBS
1 . Switch off the appliance. . Undo the screws which hold the top lamp socket in place. . Detach the
fluorescent tube with its protective cover from the top lamp socket.
lamp socket. . Remove the protective cover. . Replace the fluorescent tube. . Reassemble by 5
following the above instructions in reverse order (see fig. 7).
10. REPLACEMENT OF THE DOOR MAGNETIC GASKET
Open the door. Take hold of the magnetic gasket with your hands and pull it out of the frame.
1. 2.
3 . Insert the new gasket and press it firmly down all around (see fig. 8).
Operator's guide
2. Refrigeration switch
4 "SET or P" once to display the temperature set-point of the cell, which can
5 "UP" to increase or 6 "DOWN"
2
6
2. Remove the goods, placing them in a suitably refrigerated site. . Leave
4.
5. Do not use sharp or pointed metal tools to remove the ice from the
7 . Leave the appliance to dry with the door open before
2
6
7
1. Light switch
for turning on the refrigeration system.
Thermostat for adjusting temperature in
to reduce (see fig. 5).
4
Remove the plug, which is on the inside, at the
4. Take the tube out of the bottom
7
for
8. there is sufficient
9
3
3
I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO