Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
ENGLISH
FAILURE REMOVAL
Problem
The engine stalls, is difficult to
start or does not start
The engine turns, but stalls or does
not accelerate correctly
The engine does not engage
28
Check
Condition
The fuel does
Fuel at the carburetor
not arrive at the
carburetor
The fuel does not
arrive at the cylinder
Fuel at the cylinder
There is fuel in the
exhaust
Sparks at the spark plug
There is no spark
electrodes
Sparks at the spark plug
There is no spark
Air filter
Dirty air filter
Fuel filter
Dirty air filter
Fuel vent
Blocked fuel vent
Spark plug
Dirty or worn spark
plug
Carburetor
Bad adjustment
Cooling system
Excessive
Spark suppressor
Plate cracked,
contaminated or
perforated
N/A
N/A
Causes
Fuel filter blocked
Fuel supply blocked
Carburetor
Carburetor
The fuel mixture is too rich
Switch in off position
Electrical problem
Locked switch
Bad spacing of the electrodes
Electrodes contaminated
Electrodes contaminated
with fuel
Defective spark plug
Fair wear and tear
Dirt or residue in the fuel
Dirt or residue in the fuel
Fair wear and tear
Vibration
Prolonged use in dirty or dusty
places
Fair wear and tear
Internal engine problem
Solution
Clean or replace
Clean or replace
Ask your distributor for advice
Ask your distributor for advice
Open the throttle valve
Luftfilter reinigen oder
austauschen
Adjust the carburetor
Ask your distributor for advice
Set the switch to the ON
position (Run)
Ask your distributor for advice
Ask your distributor for advice
Adjust the gap to 0,6-0,7 mm
Clean or replace
Clean or replace
Replace the spark plug
Clean or replace
Replace
Clean or replace
Clean, adjust or replace
Adjust
Clean
Replace
Ask your distributor for advice
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
