NOCO Genius G15000EU Bedienungsanleitung Seite 5

12V
An advanced battery recovery mode for repairing and storing, old, idle, damaged, stratified or sulfated batteries. When
selected, a red LED will illuminate and flash
REPAIR
Press & Hold
16.5V | 1.5A | Any Capacity
Using 12V Lithium. [Press & Hold]
12V Lithium charge mode is designed for 12-volt lithium-ion batteries only, including lithium iron phosphate. CAUTION. USE THIS MODE
WITH CARE. THIS MODE IS FOR 12-VOLT LITHIUM BATTERIES ONLY. LITHIUM-ION BATTERIES ARE MADE AND CONSTRUCTED IN
DIFFERENT WAYS AND SOME MAY OR MAY NOT CONTAIN A BATTERY MANAGEMENT SYSTEM (BMS). CONSULT THE LITHIUM BATTERY
MANUFACTURER BEFORE CHARGING AND ASK FOR RECOMMENDED CHARGING RATES AND VOLTAGES. SOME LITHIUM-ION BATTERIES
MAY BE UNSTABLE AND UNSUITABLE FOR CHARGING. MAKE SURE YOU PURCHASE YOUR LITHIUM-ION BATTERY FROM A WELL-KNOWN
AND REPUTABLE BRAND.
Using 12V AGM+. [Press & Hold]
12V AGM+ charge mode is designed for 12-volt advanced AGM batteries only. Advanced AGM batteries are a new battery technology typically
found in startstop micro-hybrid vehicles. These batteries accept a higher than normal charging voltage around 15.5-volts. 12V AGM+ charge mode
is NOT suitable for traditional AGM batteries. Consult the battery manufacturer before using this mode. CAUTION. USE THIS MODE WITH CARE.
THIS MODE IS FOR 12-VOLT LEAD-ACID ADVANCED AGM BATTERIES ONLY. THIS MODE USES A HIGH CHARGING VOLTAGE AND MAY
CAUSE SOME WATER LOSS IN WET (FLOODED) CELL BATTERIES OR OVERCHARGE IN SOME BATTERIES.
Using 13.6V Supply. [Press & Hold]
13.6V Supply converts the charger to a constant current, constant voltage DC power supply. It can be used to power 12VDC devices, including;
tire inflators, oil changers, coffee pots, seat heaters and more. As a power supply, it can also be used to retain a vehicle's on-board computer
settings during battery repair or replacement. 13.6V Supply provides 13.6-volts at 5A with overload protection at 6A (Max). CAUTION. THIS MODE
IS FOR 12-VOLT LEAD-ACID BATTERIES ONLY. PRIOR TO USE, READ YOUR12VDC DEVICE MANUAL TO DETERMINE IF IT IS SUITABLE FOR
USE WITH THIS MODE. BOTH THE SPARK PROOF AND REVERSE POLARITY SAFETY FEATURES ARE DISABLED IN THIS MODE. DO NOT
ALLOW THE POSITIVE AND NEGATIVE BATTERY CLAMP OR EYELET TERMINAL CONNECTORS TO TOUCH OR CONNECT TO EACH OTHER
AS THE CHARGER COULD GENERATE SPARKS. CHECK THE POLARITY OF THE BATTERY TERMINALS BEFORE USING THIS MODE.
Connecting to the Battery.
Do not connect the AC cable until the connection of the battery is made first. Do not make any connections to the carburetor, fuel lines, or thin
sheet metal parts. The below instructions are for a negative ground system. If a positive ground system (very uncommon), follow the below
instructions in reverse order.
1.) Connect the positive (red) battery connector to the positive (POS,P,+) battery terminal.
2.) Connect the negative (black) battery connector to the negative (NEG,N,-) battery terminal or vehicle chassis.
EN