Werbung
en | 8 | T10031
2 General Safety Instructions
WARNING
Read and follow all safety notes and instructions!
Failure to follow the safety instructions may result in
serious injuries and material damages.
Observe and follow the safety notes below.
The load holding device has been specifically
constructed for its intended use. The safety of the
load holding device can no longer be ensured if it is
misused or modified in ways not expressly approved
by the manufacturer. Serious injuries or damage to
property can occur.
Ensure that each person using the load holding
device is familiar with these instructions and can
access them at all times.
Ensure that all users are also familiar with the
operating manuals of all tools and workshop
equipment, which are necessary for the work.
Observe and follow the basic information and safety
notes for vehicles with gas drive in the
corresponding Volkswagen Group information
materials.
Carefully read and adhere to the instructions in the
technical safety information of the Volkswagen
Group brands.
Wear safety shoes (according to ISO 20345, S2).
Wear protective gloves in order to avoid cuts.
Position hands and feet carefully to avoid potential
crushing hazards.
Use the load holding device only for work approved
by the Volkswagen Group.
Use the load holding device only with the
accessories approved by the Volkswagen Group.
Do not exceed the maximum load capacity of
100 kg.
2018-06-05
Only use the support for engine and gearbox units in
accordance with the workshop manuals of the
Volkswagen Group brands.
Tighten the wing nuts (see workshop manuals of the
Volkswagen Group brands).
Only use in connection with a suitable engine and
gearbox jack (e.g. VAS 6931/V.A.G. 1383A) (see
workshop manuals of the Volkswagen Group
brands).
The engine and gearbox jack may only be operated
by one person.
The positioning of persons under the load and in the
dangerous area is prohibited during the movement
process.
Move the load slowly and carefully.
Observe the engine support and the load during all
movements.
Only move the load on the lowest setting.
Ensure that the track is clear and easily visible.
Do not work on suspended loads.
Bosch Automotive Service Solutions GmbH
Am Dörrenhof 1
85131 Pollenfeld-Preith
Germany
Werbung
Kapitel
