Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
exceed 60°C.
Failure to follow this precaution, could cause
a malfunction in the TOUCH CONTROL
system.
POSITIONING
The domestic appliance was built in order
to be encased on a work surface, the way it
is illustrated in the graph (Fig.1). Predispose
sealing material (Fig.2) along the whole
perimeter (for dimensions of the cut see
Fig.1). Lock the domestic appliance into
place with 4 supporters, keeping in mind
the width of the surface (Fig.4). If the lower
part of the appliance after installation, is
accessable via the lower part of the furniture,
it is necessary to mount a separating panel
keeping in mind the distances indicated
(Fig.3).
VENTILATION
The distance between the cooktop and
built-in kitchen's furnitures or cooking
apparatuses
must
ventilation of the air (Fig.3). Not to use
the cooktop if in the oven is in course the
pyrolysis process.
ELECTRICAL CONNECTIONS (Fig.5)
Before making the electrical connections,
check that:
- the system ratings meet the ratings
indicated on the identification plate fixed on
the lower part of the worktop;
- the system is fitted with efficient ground
wires in accordance with the laws and
current standards.
Grounding is mandatory by law.
If the domestic appliance is not supplied
with a cable and/or suitable plug, use
material suitable for the absorption value
indicated on the identification plate and the
operating temperature. If wishing to make a
direct connection to the mains, an omnipolar
switch must be installed with a minimum 3
mm opening between the contacts and
appropriate for the load indicated on the plate
guarantee
sufficient
and in accordance with current standards
(the yellow/green ground conductor must
not be disconnected by a switch). When the
appliance has been installed, the omnipolar
switch must be easily reachable.
INDUCTION COOKING
The fundamental characteristic of the
induction system is the direct transference
of heat from the generator to the cooking
recipient.
Advantages:
- The transference of power takes place
only when the recipient is placed on the
cooking zone.
- The heat is generated only at the base of
the recipient and transferred directly to the
food to be cooked.
- Reduced heating time and low consumption
of power during the beginning of cooking,
allowing a global saving of power.
- The fibreglass top remains cold, the heat
felt on the cooking top is that reflected
from the base of the recipient.
COOKING RECIPIENTS
The use of appropriate recipients is an
essential factor for induction cooking. Check
that your pots are suitable for the induction
system. Only ferromagnetic cookware made
of the following materials is suitable for
induction cooktops:
• Enameled steel
• Cast iron
• Induction-capable cookware of stainless
steel.
To determine whether the cookware is
suitable, check whether the base of the pot
or pan attracts a magnet (Fig.6).
There are other induction-capable pots
and pans whose bases are not completely
ferromagnetic. To get good cooking results,
we recommend that the dimension of the
ferromagnetic area of the cookware match
the size of the burner.
We advise recipients having a flat base
13
Werbung
Inhaltsverzeichnis
