Product Safety Information; Product Specifications - Ingersoll-Rand 3129XP Technische Produktdaten

Product Safety Information

Intended Use:
These Polishers are designed for buffing and polishing.
For additional information refer to Product Safety Information Manual Form 04580387.
Manuals can be downloaded from www.ingersollrandproducts.com.

Product Specifications

Free
Speed
Model
rpm
3129XP 6000
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
* K = Vibration measurement uncertainty
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a
properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling discon-
nects. See drawing 16578577 and table on page 2. Maintenance frequency is shown in circular
arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
Abrasive Installation
●
Disconnect the air supply before servicing or changing the sanding pads.
● Backing Pads should be inspected for signs of irregularities such as fractures, excessive
wear, nicks, cuts, at the edges of center hole. Pads showing such characteristics should
not be used.
See drawing 16591745 on page no. 2.
A Polishing Pad
B Backing Pad
C Hold Wrench Tool here
47132634_ed1
Pad Diameter
inch mm † Pressure (L
3 76.2
6.
7.
8.
9.
WARNING
Sound Level dB (A)
(ISO15744)
) ‡ Power (L
p
83.5 94.5
Thread size
Coupling
Safety Air Fuse
Oil
EN
Vibration
(ISO28927)
m/s²
) Level *K
w
3.5 1.3
EN-1