Specifications - Ingersoll-Rand CA–EU Serie Bedienungsanleitung

TOOL OPERATION
Sand using any portion of the exposed Sanding Belt. For
best results, sand on that portion of the Belt being pulled by
the Drive Wheel.
LUBRICATION
Ingersoll–Rand No. 10
Ingersoll–Rand No. 50
Ingersoll–Rand No. 63
Always use an air line lubricator with these tools.
We recommend the following Filter–Lubricator–Regulator
Unit:
International – No. C26–C4–A29
After each two hours of operation, if an air line lubricator
is not used, inject 1/2 to 1 cc of Ingersoll–Rand No. 10 Oil
into the Air Inlet.
After each eight hours of operation, inject approximately
1 cc of Ingersoll–Rand No. 67 or Ingersoll–Rand No. 77
Grease into the Angle Head Grease Fitting. Excessive
lubrication will cause grease to work out around the
Arbor.
Model
CA120RS812ML–EU
CA120RS418ML–EU
CA120RS818ML–EU
CA200RS812ML–EU
CA200RS418ML–EU
CA200RS818ML–EU
G Tested in accordance with ANSI S5.1–1971 at free speed
Tested in accordance with ISO8662–1 sanding on steel workpiece
PLACING TOOL IN SERVICE
Ingersoll–Rand No. 67
Ingersoll–Rand No. 68
Ingersoll–Rand No. 77

SPECIFICATIONS

Belt Size Arbor
Speed
in (mm) rpm
12 x 1/2 (305 x 13) 12,000
18 x 1/4 (457 x 6) 12,000
18 x 12 (457 x 13) 12,000
12 x 1/2 (305 x 13) 20,000
18 x 1/4 (457 x 6) 20,000
18 x 12 (457 x 13) 20,000
Do not mark any nonmetallic surface of this tool with
customer identification codes. Such action could affect
tool performance.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
GSound Level
Belt
Speed
sfpm Pressure
2,700 79.1
2,700 79.25
2,700 79.25
4,500 81.4
4,500 81.4
4,500 81.4
3
FILTER
COMPRESSOR
(Dwg. TPD905–1)
Vibrations
dB (A) Level
Power
– – –
– – –
– – –
– – –
– – –
– – –
2
m/s
0.53
0.8
1.2
0.6
1.0
1.8