Miele GDU 45/60-1 Montageanleitung Seite 27

The plinth facing has three cutting lines.
^ Screw the plinth facing on to the
brackets with the cutting lines
towards the top (4x16 / TORX T20).
Then pull the facing out evenly to
align it with plinth facings on
adjoining kitchen cabinets.
If you have pulled the plinth facing
out too far you must not attempt to
push it back in. It will have to be
unscrewed and taken off. The spring
clips can then be pushed outwards
and the brackets pushed back in.
The facing can then be re-attached
and adjusted again.
^ Carefully open the dishwasher door
until the lower edge of the
dishwasher door abuts the plinth
facing (see illustration).
^ Using the front lower edge of the
dishwasher door as a guide, draw a
horizontal line across the plinth
facing.
^ Unscrew the plinth facing.
G
27