Miele GDU 45/60-1 Montageanleitung Seite 24

G
6. Adjusting the door springs
The door springs are correctly adjusted
when a half opened door (approx. 45 °
opening angle) remains in that position
when released.
If the door drops down, the door
springs need to be tightened.
If the door rises up the springs need to
be loosened.
The adjusting screws are located on
the front right-hand and front left-hand
side of the dishwasher plinth.
^ Adjust the door spring with a TORX
T20 or a 1 x 5.5 mm screwdriver until
it is correctly balanced:
– turn clockwise to tighten
– turn anti-clockwise to loosen.
24
7. Securing the dishwasher
Building-in between two kitchen
units
To ensure stability, the dishwasher must
be screwed to the adjoining kitchen
units on either side after it has been
positioned and aligned.
^ Open the dishwasher door.
^ Secure the dishwasher to the kitchen
units on the right and left hand side
with the 4 x 25 screws supplied using
a TORX T20 screwdriver.
,
Do not use a cordless
screwdriver to secure the
dishwasher to the adjoining units.
Do not remove the plastic sleeves
from the screws.
^ Plug the openings with the plastic
stoppers supplied.