Maintenance Instructions - Desoutter Industrial Tools EABC series Bersetzung Der Originalbetriebsanleitung

English

MAINTENANCE INSTRUCTIONS

Maintenance should be performed by qualified
personnel only.
● Prior to any maintenance task, disconnect the
tool.
Overhaul and preventive maintenance
is recommended at regular intervals
once per year or after maximum 500,000
tightenings depending on which occurs
sooner.
Assembly and disassembly
● When disassembling the tool electronics, take
extra care for the wires when pulling out the
connectors.
● When disassembling the tool front assemblies,
take care for the torque transducer wires.
● Follow standard engineering practices and
refer to figures/exploded view for the mounting
of component subassemblies.
● Prior to putting the equipment back into
service, check that its main settings have not
been modified and that the safety devices
work properly.
Meaning of the pictograms
Left hand thread
When reassembling, apply the
recommended glue
When reassembling, tighten to the
required torque
When reassembling, lubricate with the
required grease or oil.
Lubrication
● Do not apply too much grease on gears or
bearings; a thin coat shall be sufficient.
The use of spare parts other than those
originally supplied by the manufacturer
may result in a drop in performance or
in increased maintenance and level of
vibration and in the full cancellation of the
manufacturer's liability.
According to Directive 2012/19/
CE concerning Waste Electrical and
Electronic Equipment (WEEE), this
product must be recycled.
● Contact your Desoutter
representative or consult the website
"www. desouttertools.com" to find out
where you can recycle this product.
09/2019 13 / 108
6159928020_01