Desoutter Industrial Tools EABC series Bersetzung Der Originalbetriebsanleitung Seite 103

FCC COMPLIANCE (CLASS B)
This device complies with Part 15 of the FCC Rules. Any changes or modifications not expressly
approved by the manufacturer could void the user's authority to operate this device.
Operation is subject to the following two conditions:(1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause
undesired operation.
FCC Responsible party:
Name: Mark Johnson
Position: General Manager
Address: Chicago Pneumatic Tool Company
LLC 1815 Clubhouse Road Rock Hill
SC 29730
USA
Mobile: +1 800 624 4735
Email: mark.johnson@desouttertools.com
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
This portable equipment with its antenna complies with FCC's radiation exposure limits set forth for an
uncontrolled environment.
This equipment has shown compliance with FCC's Specific Absorption Rate (SAR) limits. To maintain
compliance, follow the instructions below:
1. This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
09/2019 103 / 108
6159928020_01