Getting Started - Desoutter Industrial Tools EABC series Bersetzung Der Originalbetriebsanleitung

English

GETTING STARTED

See page 8.
A TOOL DESCRIPTION
1. Ouput
2. Display
3. Trigger
4. Battery footprint
5. Communication module
6. eLINK module
B SCREEN AND BUTTONS
1. Screen
2. Left button
3. Right button
4. Reverse button
C LEDS COLOR CODE
1. Red
2. Green
3. Yellow
4. Blue
The battery pack and the battery charger
are delivered in separate boxes. Please
ensure you have well received these
boxes and check the contents.
INSTALLATION
● Insert the battery pack.
There is no ON/OFF switch: the tool is ready
to operate as soon as a loaded battery pack
is mounted.
● Unplug the battery pack when the tool
is not used.
● Do not leave the battery pack on the
charger when the charger power supply
is off.
EABC-eLINK
● To install the barcode reader accessory
dedicated to this tool, refer to the user manual
6159920510 available at http://resource-
center.desouttertools.com.
SET UP
See page 9.
1. Plant network
2. Ethernet link
3. Battery nutrunner
● Check you have the following equipment:
09/2019
EABC battery nutrunner
(firmware version
C3.02.02.X or higher)
CVI3 Vision controller
(firmware version 1.5.2.0
or higher)
Desoutter Wi-Fi access
point
Ethernet network
Ethernet cable (not supplied) to connect the Wi-
Fi access point to the controller
Standard PC connected to the Ethernet network
and equipped with the Desoutter CVI3 Suite
software to create and control the tightening
processes
● Before starting the set up, check that you
have the following information on hand.
Device Parameters
IP address
Network name
Wi-Fi
(SSID)
access
Security type
point
Encryption type AES/CCMP
security key
Battery
IP address
nutrunner
IP address
Controller
Communication
port
The controller IP address, subnet
mask and communication port must
be identical in the controller and the
battery nutrunner settings.
● Check with your local Desoutter
representative how to set up your
specific system environment.
● To get the complete list of the
configuration by default, refer
to the CVIMONITOR user
manual at http://resource-center.
desouttertools.com.
Wi-Fi access point
● Contact your local Desoutter representative
for more information.
11 / 108
6159928020_01
+ battery
+ charger
+ e-DOCK device
to connect the tool
to the PC
+ power cable
+ power cord
by default
192.168.5.201
Desoutter_1
WPA/WPA2PSK
mydesoutter_1
192.168.5.221
192.168.5.212
7477