Operating Mode - Desoutter Industrial Tools EABC series Bersetzung Der Originalbetriebsanleitung

6159928020_01
Battery nutrunner
When delivered, all battery nutrunners
are set with the same communication
parameters.
● Change the battery nutrunner IP
address and the communication port
to avoid settings issues.
● Insert the battery pack and plug the e-DOCK
as shown page 9.
● Connect the e-DOCK to the PC USB port. A
new serial port is created.
● Launch CVIMONITOR software and select
«Tool» tab on the top of the screen.
● Change the parameters according to your
installation.
Controller
● To install and power on the controller, follow
the instructions listed in the Quick-start user
manual 6159932290 supplied in the controller
box.
● Connect the controller to the
Ethernet network by plugging the
Ethernet cable into port 1 located
on the controller bottom panel.
● Go to the menu «»Main menu/Configuration/
Controller/Peripherals/Network.
● Check or change the controller IP address.
● Go to the menu «Main menu/Configuration/
Tightening unit/BT parameters/Network
parameters.
● Enter the communication port.
● Refer to the CVI3 Vision user
manual at http://resource-center.
desouttertools.com.

OPERATING MODE

When the tool is powered on, the Desoutter logo
is displayed and the LEDs are blinking.
● Wait for a few seconds while the software is
being initialized.
● Refer to the user manual 6159921030 at
http://resource-center.desouttertools.com to
learn how to set up and use the functionalities
of the software embedded in the tool.
Barcode reader
● See page 9.
BARCODE READER
F
1 Power ON
2 Scan
3 Scan OK
4 Scan button
5 Laser beam
Warning!
Laser radiation
● Do not stare into beam.
● Press briefly the "Scan button"
The orange LED "Scan" is activated during 3
seconds by default.
As soon as the barcode is read, the beam comes
off, the green LED "Scan ok" is on.
Other settings possible with CVI CONFIG
● Launch "CVI CONFIG" and go to the "Tool"
tab.
● Extend or shorten the scan time from 1 to 9
seconds.
● Use the trigger to scan the barcode. In that
case, the tool must be locked before pressing
the trigger and the "Stop" icon displayed on
the controller display.
● To prevent the operator from using the "Scan
button", untick the box "Scan button".
● Refer to the CVI CONFIG user
manual at http://resource-center.
desouttertools.com
12 / 108
English
09/2019