Kerbl 1085 Bedienungsanleitung Seite 26

Protective hood
Lens
IR - LED´s
Day/Night sensor
Channel dip switch
Mounting foot
Wireless CCD Camera (Art. nr 1087)
Transmitting channel
indicator
Yagi antenna
connection (for
1072 cable 10dBi)
Manual/Loop switch
CH dip lock switch
Receiving channel switch
Wireless AVLink for indoor range extension (Art. nr 1092)
Manual/Loop switch
This switch is on the left side of AVLink and can set AVLink to manually change the receiving channel or automatically change the receiving
channel based on the adjustable change interval among selected channels. If the switch is on "M" position which stands for manual operation,
receiving channel will not change automatically. If the switch points to a value, then the channel loop interval will be that value represented
seconds. AVLink now supports adjustable loop interval from 5 ~45 seconds (See illustration below). Each step is 5 more seconds.No matter
AVLink is on Manual or Loop status, monitor shall be always placed on the same channel as resending channel to see the image.
Channel microswitches
The microswitches are also located on the left-hand side of AVLink. Moving the microswitches to „ON" or „OFF" causes channels to be selected
or blocked (above all in the loop function).
Antenna (2dBi)
Receiving channel indicator
Bracket
Video out for TV
Power socket (5V)
Wireless 2.5" LCD monitor (Art. nr 322032)
Channel switch (4)
The channel switch enables AVLink to switch the receiving
channel between channels 1 - 4. The default receiving
Transmitting
channel switch
channel is channel 4. If the switch is pressed, the recei-
ving channel changes to channel 3, 2 then 1. Pressed
Transmitting
again it switch back channel 4. This switch overrides
black antenna
manual/loop switch but does not exit loop if it loop is set.
(5dBi)
When AVLink receives a signal, it transmits it on either
channel 1, 2 or 3 via the planar antenna. The default
Power socket
(5V) transmitting channel is channel 1. If the switch on the
right-hand side is pressed, the transmitting channel
A/V out (for TV)
changes to channel 2 or 3. Changing resending channel
becomes useful when you see a possible interference
source at home for channel 1 and want to avoid it.
Corresponding LED indicators will be displayed on the
front cover for receiving and resending channels.
26
LCD display
Volume
On/Off button
Channel switch
Channel indicator
Speaker