Functional Description - Makita DVC340 Bedienungsanleitung

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the cleaner is switched off and
•
the battery cartridge is removed before adjusting or
checking function on the cleaner.
Installing or removing battery cartridge
Fig.1
CAUTION:
Always switch off the cleaner before installing or
•
removing of the battery cartridge.
Hold the cleaner and the battery cartridge
•
firmly when installing or removing battery
cartridge. Failure to hold the cleaner and the
battery cartridge firmly may cause them to slip off
your hands and result in damage to the cleaner and
battery cartridge and a personal injury.
To remove the battery cartridge, slide it from the cleaner
while sliding the button on the front of the cartridge.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip it
into place. Insert it all the way until it locks in place with a
little click. If you can see the red indicator on the upper
side of the button, it is not locked completely.
CAUTION:
Always install the battery cartridge fully until the red
•
indicator cannot be seen. If not, it may accidentally
fall out of the cleaner, causing injury to you or
someone around you.
Do not install the battery cartridge forcibly. If the
•
cartridge does not slide in easily, it is not being
inserted correctly.
Battery protection system
The cleaner is equipped with the protection system, which
automatically cuts off the output power for its long service life.
The cleaner stops during operation when the cleaner
and/or battery are placed under the following situation.
This is caused by the activation of protection system and
does not show the cleaner trouble.
When the cleaner is overloaded:
•
At this time, press the "OFF" button and
remove causes of overload and then press
the "HIGH/LOW" button again to restart.
When battery cells get hot: (refer to the note below.)
•
If any operation of the "HIGH/LOW" button
and the "OFF" button, the motor will remain
stopped. At this time, stop use of the cleaner
and cool or charge the battery cartridge after
removing it from the cleaner.
When the remaining battery capacity gets low:
•
If any operation of the "HIGH/LOW" button
and the "OFF" button, the motor will remain
stopped. At this time, remove the battery
cartridge from the cleaner and charge it.
NOTE:
This temperature-sensitive protection is applied
•
only when the cleaner is used with a battery
cartridge with a star mark.
Fig.2
Indicating the remaining battery capacity
(Only for battery cartridges with "B" at the end of the
model number.)
Fig.3
Press the check button on the battery cartridge to
indicate the remaining battery capacity. The indicator
lamps light up for few seconds.
Indicator lamps
Lighted Off
015658
NOTE:
Depending on the conditions of use and the
•
ambient temperature, the indication may differ
slightly from the actual capacity.
Switch action
Fig.4
To start the cleaner, simply press the "HIGH/LOW" button.
To switch off, press the "OFF" button. To change the
cleaner speed, press the "HIGH/LOW" button. The first
press on this button is for high speed and the second
press for low speed and then each press on this button
repeats the high/low speed cycle alternatively.
ASSEMBLY
CAUTION:
Always be sure that the cleaner is switched off and
•
the battery cartridge is removed before carrying out
any work on the cleaner.
Any work with the battery cartridge being installed
•
on the cleaner may cause a personal injury or
damage to the objects around the cleaner.
7
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.