Troubleshooting - Rowi RAS 800/18/1 Inox Basic Bedienungsanleitung

The fluted filter is a wearing part and must be replaced from time to time. Therefore
check the condition of the filter after every cleaning. The filter must be replaced if it
is damaged or clogged up.
5.3

Troubleshooting

Note that only original parts may be used for repair and maintenance work. Contact the
ROWI Service Center if need be (see Chapter 6).
Fault
Appliance does not
start.
Insufficient or no suc-
tion power
Appliance makes an
unusual noise.
Possible cause(s)
No power or voltage too
low.
Appliance is not switched
on.
Container is full.
Appliance head is not cor-
rectly attached.
The suction hose or
suction tube is blocked.
The fluted filter is clogged.
The suction hose or
suction tube is blocked.
Container is full.
31/40
Remedy
Make sure the plug is plugged
into the socket. Check the fuse
and replace this, if necessary.
Check the power supply vol-
tage.
Set the ON/OFF switch to
position I.
Check the container
content and empty if required.
Check whether the appliance
head is correctly attached.
Check the suction hose and
suction tube and remove any
dirt deposits that may have
accumulated.
Switch off the motor and clean
the filter. For this, tap the dust
off the fluted filter or blow it out
with compressed air. The filter
must be replaced if it is very
dirty. Contact the ROWI Service
Center for this.
Check the suction hose and
suction tube and remove any
dirt deposits that may have
accumulated.
Check the container content
and empty if required.
GB