Herunterladen Inhalt Inhalt Diese Seite drucken

Specific Safety Notes; Preparing The Product For Operation; Unpacking The Scope Of Supply - Rowi RAS 800/18/1 Inox Basic Bedienungsanleitung

Aschesauger
Vorschau ausblenden Andere Handbücher für RAS 800/18/1 Inox Basic:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Inspect regularly. Use of this appliance can cause certain parts to become
worn. Therefore check the appliance regularly for signs of damage and defects.
Only use original accessories. For your own safety, only use accessories and addi-
tional devices that are expressly recommended in the operating instructions or by the
manufacturer.
Do not use in explosive zones. Do not use the appliance in an explosive environment
containing substances such as flammable liquids, gases and especially spray and dust mist.
These substances can ignite due to hot surfaces on the appliance.
GB

2.6.2 Specific safety notes

P Only use extension cables approved for outdoors when working in the open air. The plug
and socket must be waterproof and the cable must have the following cross section corre-
sponding to the required length: 1.5 mm
a maximum length of 15 m. Unsuitable extension cables can be dangerous
P Do not use this appliance to vacuum up toxic, corrosive or harmful substances.
P Only use this appliance to vacuum up ash from admissible fuels.
P Do not use this appliance to vacuum up water or other liquids.
P Do not use this appliance to vacuum up soot.
P Do not use this appliance to vacuum up flammable fuels.
P Do use this appliance to vacuum up hot, burning or glowing substances (e.g. hot ash).
P Only use this appliance for vacuuming up cold ash. Do not use this appliance to vacuum
clean heating boilers or oil-burning stoves and do not take up plaster or cement dust.
P Do not take up ash whose temperature is above 40°C.
P Not approved for the separation of harmful dusts (dust class L, M, H)
P Empty and clean the vacuum cleaner after and before use so as to prevent the accumu-
lation of materials forming a fire load in the vacuum cleaner.
3.

Preparing the Product for Operation

3.1

Unpacking the scope of supply

Check whether the scope of supply is complete and free of defects immediately after ope-
ning the packaging. Contact the seller immediately if the scope of supply is incomplete or
defective. Do not put the appliance into operation if it is defective.
2
with a maximum length of 10 m or 2.5 mm
26/40
2
at

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis