Machine Does Not Start; Pad Motor Does Not Operate; Impossible To Lift Or Lower The Base; Electrical Fuses And Thermal Cutouts - COMAC CM50hs Bedienungsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

MACHINE DOES NOT START

1. Check that parking brake pedal (1) is released

2. Check that connector (2) is connected to the batteries

3. Check that key-operated switch (3) is on

4. Check signal device (4) to make sure the batteries are charged

5. Check that no thermal cutout has tripped (see ELECTRICAL FUSES AND THERMAL

CUTOUTS)

WARNING!

WARNING! The pad motor only starts when the machine is moving forward in order to

WARNING!

prevent damage to the floors

1. Check that the base is lowered down

2. Check the signal device to make sure the batteries are charged

3. Check that no thermal cutout has tripped.

Check that the thermal cutout has not tripped (see ELECTRICAL FUSES AND THERMAL

CUTOUTS)

The machine is equipped with the following electrical protection systems:

Power fuses placed on the machine left side to protect against short-circuits.

Whenever a fuse blows check for the causes of the malfunction carefully and

eliminate them before replacing the fuse.

Low-current resettable fuses to protect:

•

General services

•

Traction control system

When a resettable fuse trips first turn the key to OFF (1), wait a few seconds and then turn

the key to ON (2).

Turn to your authorized COMAC Service Center if the problem persists.

SOLUTION FOR THE MOST FREQUENT TROUBLES

Inhaltsverzeichnis

Inhaltsverzeichnis