Connecting The Battery Connector; Battery Charge Level Gauge; Installing The Pad - COMAC CM50hs Bedienungsanleitung

10. 10. 10. 10.

CONNECTING THE BATTERY CONNECTOR

CONNECTING THE BATTERY CONNECTOR CONNECTING THE BATTERY CONNECTOR CONNECTING THE BATTERY CONNECTOR
Battery connector (1) must be connected to machine connector (2)
11. 11. 11. 11.

BATTERY CHARGE LEVEL GAUGE

BATTERY CHARGE LEVEL GAUGE BATTERY CHARGE LEVEL GAUGE BATTERY CHARGE LEVEL GAUGE
The battery charge level gauge is a digital unit with 4 fixed and one flashing position.
The numbers on the display give an approximate idea of the state of charge:
4 4 4 4 = maximum charge, 3 3 3 3 = 3/4 charge, 2 2 2 2 = 2/4 charge, 1 1 1 1 = 1/4 charge, 0 0 0 0 = batteries
discharged (flashing)
WARNING! WARNING! WARNING! WARNING! The brush motor automatically turns off a few seconds after
the flashing "0" appears. The remaining charge can be used to move the
machine to the recharging point.
12. 12.

INSTALLING THE PAD

INSTALLING THE PAD
12. 12. INSTALLING THE PAD INSTALLING THE PAD
1. Connect the battery connector
2. Turn the key to "1"
3. Operate the lever to lift the base
4. Turn the key to "0" and pull it out from the dashboard
WARNING! Make sure no persons or objects are in the vicinity of the WARNING! WARNING! WARNING!
base when doing this.
5. Keep the base in its raised position. Unscrew (rotating counterclockwise) ring (1).
Install pad (2) on the disk drive plate. Use one hand to support the pad and the
other to tighten the fastening ring (rotating it clockwise), using handle (3) provided
with the machine.
WARNING! Wear suitable safety gloves before installing the pad. WARNING! WARNING! WARNING!
PREPARING THE MACHINE PREPARING THE MACHINE
PREPARING THE MACHINE PREPARING THE MACHINE
26
2
1
3
1
3
1
2
4
2