Daily Maintenance; Replacing The Dust Collection Filter; Removing The Pad - COMAC CM50hs Bedienungsanleitung

REPLACING THE DUST COLLECTION FILTER

REPLACING THE DUST COLLECTION FILTER REPLACING THE DUST COLLECTION FILTER REPLACING THE DUST COLLECTION FILTER
1. Lift the hood and install the safety strut
WARNING! WARNING! Use gloves when doing this to protect yourself against contact
WARNING! WARNING!
with dangerous liquids.
2. Lift the filter up and out
3. Install a new filter (3) in the filter seat
4. Remove the safety strut and lower the hood

REMOVING THE PAD

REMOVING THE PAD
REMOVING THE PAD REMOVING THE PAD
1. Connect the battery connector if it is not connected
2. Turn the key to position "1"
3. Use the control switch to lift the base (if it isn't already lifted)
4. Turn the key to "0" and pull it out from the dashboard (hand injuries may be caused if
the pad is removed with power on)
WARNING! WARNING! WARNING! WARNING! Make sure there are no objects or persons in the vicinity of the
base when doing this.
5. Keep the base in its raised position. Unscrew (rotating counterclockwise) fastening
screw (2) using handle (1) provided with the drive disk. Replace pad (3). Use one
hand to support the pad and the other to tighten ring (2) (rotating it clockwise) using
handle (3).
WARNING! Wear gloves when doing this to protect yourself against WARNING! WARNING! WARNING!
possible contact with dangerous materials and liquids.
0

DAILY MAINTENANCE

DAILY MAINTENANCE
DAILY MAINTENANCE DAILY MAINTENANCE
31
3
1
3
2
1
2
2
4
3