Preparing The Machine; Moving The Packaged Machine; How To Unpack The Machine; Connecting The Traction Motor Cable (Machines With Traction) - COMAC CM50hs Bedienungsanleitung

1. 1. 1. 1.

MOVING THE PACKAGED MACHINE

MOVING THE PACKAGED MACHINE MOVING THE PACKAGED MACHINE MOVING THE PACKAGED MACHINE
The machine is contained in specific packing with a platform so that it can be moved by
a fork-lift. More than two packings cannot be stacked.
Total weight is 180 kg (without batteries)
Packing dimensions are:
2. 2. 2. 2.

HOW TO UNPACK THE MACHINE

HOW TO UNPACK THE MACHINE HOW TO UNPACK THE MACHINE HOW TO UNPACK THE MACHINE
1. Remove the outer packing.
2. The machine is fastened to its platform by wedges that clamp its wheels.
3. Remove the wedges.
4. Use a ramp to lower the machine off the platform, pushing it in reverse. Avoid
violent blows to the base.
5. Keep the platform since it may be necessary to transport the machine again.
3. 3. 3. 3.

CONNECTING THE TRACTION MOTOR CABLE (machines with traction)

CONNECTING THE TRACTION MOTOR CABLE (machines with traction)
CONNECTING THE TRACTION MOTOR CABLE (machines with traction) CONNECTING THE TRACTION MOTOR CABLE (machines with traction)
WARNING! This procedure must be done by a COMAC WARNING! WARNING! WARNING!
technician.

PREPARING THE MACHINE

PREPARING THE MACHINE PREPARING THE MACHINE PREPARING THE MACHINE
A: A: A: A: 1230 mm
B: B: B: B: 740 mm
C: C: C: C: 1490 mm
COMAC Service Center COMAC COMAC
23
A
C
B