Extraordinary Maintenance; Replacing The Base Splashguards - COMAC CM50hs Bedienungsanleitung

REPLACING THE BASE SPLASHGUARDS

REPLACING THE BASE SPLASHGUARDS
REPLACING THE BASE SPLASHGUARDS REPLACING THE BASE SPLASHGUARDS
Periodically check the state of wear of the base splashguards. To replace them proceed
as follows:
1. Lift the base
2. Install the pad
3. Lower the base until it touches the floor
4. Turn the key to "0" and pull it out from the dashboard
5. Loosen nut (1) and pull out the splashguard blade (2)
6. Remove the splashguard rubber and replace it
7. Reinstall everything by performing these procedures in reverse order. Make sure the
rubber touches the floor.

EXTRAORDINARY MAINTENANCE

EXTRAORDINARY MAINTENANCE
EXTRAORDINARY MAINTENANCE EXTRAORDINARY MAINTENANCE
32
1
2