Operation; Preparing To Work - COMAC CM50hs Bedienungsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

1. Prepare the machine for operation

2. Check that the parking brake is released (1)

3. Connect the battery connector (2)

4. Turn main switch key (3) clockwise to "1". Display (4) on the dashboard will

immediately turn on and indicate the level of the battery charge and the hour counter.

6. Press base-pad lift-lower switch (5) down to lower the base. The brush will only start

to rotate when you actuate the control lever on the handlebar.

7. Select forward speed turning knob (7). The selector has three positions, indicated by

symbols: turtle = slow speed, middle position = normal speed, rabbit = fast speed

8. The machine starts to move forward by actuating man-present lever (8) on the

handlebar. The base will start to lower and when it is all the way down the polishing

pad will start to rotate (release the lever on the handlebar and the base will lift a few

centimeters and the pad will stop)

9. Check work quality during the first few meters of work.

Whenever problems arise during operation turn off key (1), quickly detach emergency

lever (2) placed below the operator and set the emergency brake by pushing lever (3)

down. These procedures will block all machine movements. To start working again, after

down.

you have solved the problem, reconnect connector (2), turn key (1) and release parking

brake lever (3).

OPERATION

Inhaltsverzeichnis

Inhaltsverzeichnis