Livox Hub Betriebsanleitung - Kurzfassung Seite 6

Livox Hub Quick Start Guide
Connection
Cables
Power Cable
Connects to the Livox Hub power port
GPS Sync Cable
Connects to the Livox Hub GPS sync port
Refer to the Livox Hub User Manual for more information about the cables.
Connecting the Livox Hub
Before connecting, make sure to use CAT5E or above Gigabet Ethernet cables and a Gigabit
router. The voltage of the external power supply should be from 10 V to 23 V. The data of Livox
Hub is transmitted using an Ethernet cable. Addresses are assigned by default to a Livox Hub
using the Dynamic Host Configuration Protocol (DHCP). When connecting Livox Hub for the first
time, it is recommended to use a router.
The Livox Mid-40 is used in the example below.
PC
1. Connect the Livox Mid-40 to Livox Hub (A Livox Hub can connect up to nine Livox LiDAR
sensor units).
2. Connect the computer and Livox Hub to the router using Ethernet cables.
3. Connect Livox Hub to an external power source.
• Make sure both Livox Hub and the computer are connected to the LAN port on the router.
• Please contact Livox if you intend to use an external power source exceeding 23 V.
4
Ethernet Cable
Ethernet Cable
Gigabit Router (DHCP)
Red (Positive); Black (Negative)
White (PPS_N); Blue (PPS_P); Yellow
(STAMP_N); Grey (STAMP_P); Black (GND)
External Power Source
Livox Mid-40
Unit: mm