Replacing The Bulb; What Should I Do If - Atag kb 611 m Bedienungsanleitung

maintenance

replacing the bulb

Attention: Switch the appliance off before you replace the
light bulb. Remove the plug from the socket or turn the
switch in the meter cupboard to zero. Never pull the plug out
of the socket by the cable. Always take hold of the plug itself
and pull it straight out of the socket (see also 'safety', page 4).
1. Take hold of the light bulb via the opening at the back of
the fitting.
2. Unscrew the light bulb.
3. Replace the light bulb.
4. Connect the appliance again.
Attention : Use only light bulbs of the same type and with
replacing light bulb
the following characteristics:
– voltage 230 V;
– fitting E14;
– maximum wattage 15 W.
GB 18
fault cause
Appliance does not do Plug is not in socket.
anything; light is not on.
Fuse is defective.
Temperature in refrigerator Thermostat set incorrectly.
compartment / Biofresh 3
°C compartment is too high
or too low.
Water is leaking from the Meltwater drain blocked.
refrigerator compartment /
Biofresh 3 °C compartment.
Appliance makes a noise. Food incorrectly arranged in
the refrigerator
compartment / Biofresh
3 °C compartment.
There is an object touching
the appliance.
Lighting is not on. Light bulb is defective.
faults

what should I do if...

solution
Put the plug into the
socket.
Replace the fuse.
Set the thermostat
correctly.
Clear the meltwater drain.
Arrange the food differently
in the refrigerator
compartment / Biofresh
3 °C compartment.
Remove the object.
Replace the light bulb.
GB 19