Before Use - Taurus STRIKER 2.0 Gebrauchsanweisung

directly affecting battery life.
- Make sure that the On/Off switch is set to "0"
before fitting the batteries.
- Remove the cover of the battery compartment.
- Put the battery in its compartment, respecting
the polarity (Fig. 2).
- Close the cover of the
- battery compartment.
INSTRUCTIONS FOR USE

BEFORE USE:

- Remove the appliance's protective film.
- Make sure that all the product's packaging has
been removed.
- Before using this product for the first time, it is
important to make a full charge of batteries.
- Prepare the appliance according to the function
you wish to use.
ASSEMBLING THE SIDE BRUSHES:
- Fit the side brush onto the side brush support.
- Press until it clicks. (Fig.3).
ASSEMBLING THE MOP:
- Stick the mop onto the mop holder (Fig. 4a).
- Adjust the chamois support on the body's an-
chor points. (Fig.4b).
- Remove the chamois support if the robot is
going to be used without a chamois.
USE:
- Once the appliance is charged, use the On/
Off switch on the side of the robot to start the
appliance, and press the ON/OFF button on the
top of the robot.
- The appliance will start to work automatically
until its batteries are exhausted.
- The red low-battery indicator will light up while
the appliance is running.
- Remove the chamois stand before using the
robot on carpets or rugs.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Use the On/Off switch on the side of the robot
to stop the appliance, and press the ON/OFF
button on the top of the robot.
- Remove the batteries from the appliance if you
are not going to use it for some time.
- Clean the appliance
CLEANING
- Disconnect the charger from the mains and let it
cool before undertaking any cleaning task.
- Remove the battery before starting any cleaning
operation.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Do not submerge the appliance in water or any
other liquid, or place it under a running tap.
- Never submerge the connector in water or any
other liquid or place it under running water.
EMPTYING THE DUST BOX:
- Empty the dust box each time after use.
- Open the lid of the dust box. (Fig.5)
- Disconnect the dust box from the appliance..
(Fig.6)
- Open the lid of the dust box,
- empty the contents into the appropriate waste
disposal receptacle.
- Check the condition of the dust box filter and
refit it.
- Close the lid of the dust box.
- Attach the dust box to the appliance.
CHANGING THE FILTERS:
- It is recommended that the dust box filter should
be changed every three months.
- To remove the filters:
- Open the lid of the dust box. (Fig.5).
- Disconnect the dust box from the appliance.
- Open the dust box emptying lid and remove the
dust box filter from its bracket (Fig.7).
- To reassemble the filter, proceed with the above
instructions, in reverse order.
CLEANING THE CHAMOIS
- Pull on the chamois until it comes free (Fig. 8)
- The chamois can be washed with soapy water
or in the washing machine.
- To fit the chamois, follow the instructions in the
previous section but in reverse order.
CHANGING THE SIDE BRUSHES:
- To remove the side brushes:
- Pull on the brush's bristles so that the side