Before Use - Taurus ULTIMATE LITHIUM Bedienungsanleitung

CHARGING THE BATTERY
- Caution: A new battery is not fully charged and
must therefore be charged before the appliance
is used for the first time.
- Charge the battery at an atmospheric tempera-
ture of between 4 and 40ºC.
- Plug the charger (P) into the mains.
- A pilot light will come on to indicate that the
charger is ready to begin charging the battery.
- Approximately 3 to 4 hours are needed for a
complete charge of the battery. Never attempt to
over-charge the battery (although it is recom-
mended that the first charge of the battery be of
5 hours in duration).
- Connect the charger to the jack using the socket
on the appliance. The socket is located at the
back part of the appliance.
- The pilot light will come on to indicate that the
charger is charging the battery.
- At the end of the time period specified above,
remove the battery from the charger.
- When the battery is charged disconnect the
charger from the mains supply.
- NB: Do not use the appliance while it is connec-
ted to the charger.
INSTRUCTIONS FOR USE

BEFORE USE:

- Make sure that product's packaging has been
removed.
- Before using this product for the first time, it is
important to make a full charge of batteries.
- Prepare the appliance according to the function
you wish to use:
VACUUMING FUNCTION:
- Connect the tube in the air intake and the brush
at the end of the extencion tube. (H)
- To disconnect the extension tube of the vacuum
cleaner, press the release button of accessories
(H) and pull out. (Fig.3)
USE:
- Turn the appliance on, by using the on/off
button. (J)
- Turn the appliance on, by using one of the spe-
ed selection buttons.
FITTING AN ACCESSORY TO THE HAND
VACUUM:
- The folloring accessory is designed to inster
into handy vacuum cleaner and extention tube.
(Fig. 4)
- Accessory 3 in 1:
A-1 Upholstery brush.
A-2 Brush for furniture or textile.
A-3 Lance.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off using the on/off button.
- Remove the battery from the appliance if you
are not intending to use the appliance during an
extended period.
- Clean the appliance.
CLEANING
- Disconnect the battery charger from the mains
and allow it to cool before undertaking any
cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
EMPTYING THE DUST BOX
- Empty the dust box when it is full (observation
facilitated by transparent windows), or when
vacuuming power is notably reduced.
- Disconnect the hose from the vacuum cleaners
air intake. (Fig.5).
- Open the lid of the dust box and empty the
contents into the appropriate waste disposal
receptacle. (Fig.6).
- To clean the cyclone, disconnect the dust tank
pressing the butoon, turb the dust tank to the
left and pull out. (Fig.7)
CHANGING THE FILTERS:
- Dust tank HEPA filter (high efficiency air filter
that efficiently retains spores, ash, sawdust,
pollen...), it is advisable to change it a least
once a year or after every 50 hours of use, or if
its potency diminishes remarkably.
TO REMOVE THE FILTERS:
- Open the cover that contains the filter. (Fig.8).
- Remove the filter from its housing (Fig.9).
- To reassemble the filter, proceed with the above
instructions, in reverse order.