Before Use - Taurus STRIKER MINI Handbuch

- Adjust the mop holder in the couplings of the
robot body (Fig.4b)
- Remove the mop holder if you are going to use
the robot without mop.
INSTRUCTIONS FOR USE

BEFORE USE:

- Before using this product for the first time, it is
important to make a full charge of batteries.
USE:
- Turn the appliance on using the on/off switch.
- The appliance will begin to function automatica-
lly until its batteries run out.
- While the appliance is operating the battery
charging/battery charged and battery low indica-
tor lamps will alternate.
- When the batteries are low, the red battery low
indicator lamp will light up.
- Remove the platform for mops before using the
robot on rugs or carpets.
- When using the robot on a dark surface, set the
height sensors at Position 2 or 3. (Fig.11)
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off, using the on/off switch.
CLEANING
- Disconnect the appliance from the mains and let
it cool before undertaking any cleaning task.
- Disconnect the charger from the mains and let it
cool before undertaking any cleaning task.
- Remove the battery before starting any cleaning
operation.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Do not submerge the appliance in water or any
other liquid, or place it under a running tap.
- Never submerge the connector in water or any
other liquid or place it under running water.
EMPTYING THE DUST BOX:
- Empty the dust box each time after use.
- Open the lid of the dust box. Fig.5
- Disconnect the dust box from the appliance.
(Fig.6)
- Open the dust box emptying lid and empty its
contents into a suitable rubbish bin (Fig.7)
- Check the condition of the dust box filter and
replace it.
- Close the lid of the dust box.
- Attach the dust box to the appliance.
CHANGING THE FILTERS:
- It is recommended that the dust box filter should
be changed every three months.
TO REMOVE FILTERS:
- Open the lid of the dust box. (Fig. 5)
- Disconnect the dust box from the appliance.
- Open the dust box emptying lid and remove the
dust box filter from its bracket. (Fig.7)
- To reassemble the filter, proceed with the above
instructions, in reverse order.
CHANGING MOPS:
- To remove the mop.
- Remove the mop holder by carefully pressing
the teeth which secure it and pulling the holder
(Fig.8)
- Pull the mop until it disengages from the cou-
plings which secure it (Fig.9)
- To install mops, proceed with the above instruc-
tions in reverse order.
CHANGING SIDE BRUSHES:
- To remove the side brushes.
- Pull the bristles of the brush until it disengages
from the side brush assembly. (Fig.10)
- To install side brushes, proceed with the above
instructions in reverse order.
SUPPLIES:
- Supplies can be acquired from distributors and
authorised establishments (such as filters, etc.)
for your appliance model.
- Always use original supplies, designed specifi-
cally for your appliance model.