Herunterladen Diese Seite drucken
Velleman PLUG & PLAY Bedienungsanleitung
Velleman PLUG & PLAY Bedienungsanleitung

Velleman PLUG & PLAY Bedienungsanleitung

Kit für cu2101/cu2201

Werbung

CU2101/KIT – PLUG & PLAY KIT FOR CU2101/CU2201
1. Introduction & Features
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the CU2101/KIT! Please read the manual thoroughly before bringing this device into service. If the
device was damaged in transit, don't install or use it and contact your dealer.
2. Safety Instructions
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
• All modifications of the device are forbidden and any ensuing damage is not covered by the warranty.
• Only use the device for its intended purpose. Using the device in an unauthorised way will void the warranty.
• Protected the device against extreme heat, dust and moisture.
3. Contents
1. 220VAC/12VDC adapter
2. distribution block
3. UTP cable (2 x 5m included)
4. motion detector (1 included) or smoke detector or reed switch
(1 included)
5. key switch, motion detector, smoke detector or reed switch.
4. Preparation
1. Place the SIM card in your mobile phone. Deactivate the PIN
code (see your mobile phone's user manual).
2. Erase all Telephone numbers on the SIM card.
3. Remove and replace the SIM card.
4. Enter the phone number to which the CU2101 must call in case
of an alarm into memory 1.
5. Remove the SIM card from the mobile phone and place it in the CU2101.
6. Program the alarm telephone number of the CU2101 which must be dialled into your mobile phone. Name that
telephone number (e.g. Alarm Unit).
7. Connect a 12VDC/5mA power supply through either a power adapter or a battery. Never connect a battery
charger loading the CU2101 with a battery.
8. Connect the included UTP cable.
9. Switch on the CU2101. The red LED lights. Switch off the CU2101.
10. Connect the orange wire of the UTP cable to the COM of the sensor. Connect the orange/white wire of the UTP
cable to the NO. The CU2101 will now dial the programmed telephone number. Accept the call and break off the
connection.
CU2101/KIT
- 1 -
VELLEMAN

Werbung

loading

Inhaltszusammenfassung für Velleman PLUG & PLAY

  • Seite 1 10. Connect the orange wire of the UTP cable to the COM of the sensor. Connect the orange/white wire of the UTP cable to the NO. The CU2101 will now dial the programmed telephone number. Accept the call and break off the connection. CU2101/KIT - 1 - VELLEMAN...
  • Seite 2: Veiligheidsinstructies

    • As indicated under number 5 in the drawing, a key switch can also be connected, enabling you to switch the CU2101 on and off from outside the protected area. For more info concerning this product, please visit our website www.velleman.eu. The information in this manual is subject to change without prior notice.
  • Seite 3: Prescriptions De Sécurité

    • Zoals aangegeven onder nummer 5 in de figuur, kan een sleutelschakelaar worden aangesloten om de CU2101 in en uit te schakelen van buiten het beschermde gebied. Voor meer informatie omtrent dit product, zie www.velleman.eu. De informatie in deze handleiding kan te allen tijde worden gewijzigd zonder voorafgaande kennisgeving.
  • Seite 4: Introducción & Características

    • Comme indiqué sous le numéro 5 dans l’illustration, un commutateur à clef peut être connecté afin de permettre l’allumage et l’extinction du CU2101 d'en dehors de l'endroit protégé. Pour plus d’information concernant cet article, visitez notre site web www.velleman.eu. Toutes les informations présentées dans ce manuel peuvent être modifiées sans notification préalable.
  • Seite 5: Einführung & Eigenschaften

    • Como se indica bajo el número 5 en la figura, es posible conectar un contacto a llave para permitirle activar y desactivar el CU2101 desde fuera del lugar protegido. Para más información sobre este producto, visite nuestra página web www.velleman.eu. Se pueden modificar las especificaciones y el contenido de este manual sin previo aviso.
  • Seite 6: Sicherheitsvorschriften

    • Melder, Schalter usw. müssen des NO-Typs sein (normal offen). • Wie in der Abbildung unter Nummer 5 gezeigt wird, kann ein Schlüsselschalter angeschlossen werden um den CU2101 von aus dem geschützten Bereich ein- oder auszuschalten. Für mehr Informationen zu diesem Produkt, siehe www.velleman.eu. Alle Änderungen vorbehalten. CU2101/KIT...

Diese Anleitung auch für:

Cu2101/kit