English; Care And Cleaning - Kenwood ZJM810 Bedienungsanleitungen

before plugging in
Make sure your electricity supply is
l
the same as the one shown on the
underside of your kettle.
WARNING: THIS APPLIANCE
l
MUST BE EARTHED.
This appliance conforms to EC
l
Regulation 1935/2004 on materials
and articles intended to come into
contact with food.
before using for the first
time
1 Wrap any excess cord around the
bracket e on the underside of the
powerbase.
2 Fill to 'MAX', boil, then pour the
water away. Repeat 3 times.
key
a lid
b on/off switch
c 360° powerbase
d power on light
e cord wrap
f filter
water level gauge
A
to use your kettle
1 Fill the kettle by removing the lid.
The water level must be between
'MAX' and 'MIN' (250mls) on the
water level gauge inside the kettle
(A).
If you live in a hard water area we
l
recommend that you use filtered
water in order to maintain the
appearance and efficiency of your
kettle.
Be economical: do not boil more
l
water than you need.
To improve the quality of your
l
drinks always use fresh water.
Empty the kettle after each use.
l
Rinse out with fresh water if the
l
kettle has not been used for more
than 2 days.
2 Check the lid is fitted correctly.
3 Plug in and switch on. The power
on light d will come on.
4 Your kettle will boil and switch off
automatically. To re-boil, wait a few
seconds - the on/off switch needs
time to reset.

English

Note - To interrupt the
boiling ensure that the
switch is in the off position
before removing from the
powerbase.
If you experience problems
l
with your kettle switching
on and off during use or
switching off before boiling,
check that the flat element
is free from scale - see
"descaling".
Your kettle is fitted with a filter to
l
hold back limescale particles.
If you find drops of water under
l
your kettle, do not worry - it is just
condensation.
boil-dry protection
If you switch on with too little
l
water, your kettle will cut out
automatically. Switch off, remove
from the powerbase and let it cool
down before re-filling. When it has
cooled down, the switch will reset
itself.

care and cleaning

Before cleaning, unplug your kettle
l
and let it cool down.
the outside and powerbase
Wipe with a damp cloth, then
l
dry. Do not use abrasives - they
will scratch the metal and plastic
surfaces.
the inside
Wipe with bicarbonate of soda on
l
a damp cloth. Rinse thoroughly.
Even though your kettle comes
l
with a filter, you still need to clean
the inside (and the filter) regularly.
the filter (B+C)
1 Remove the lid.
2 Lift the filter out away from the
spout area (B).
3 either rinse under the tap or use
a soft brush or when descaling
your kettle, drop the filter in too.
Rinse thoroughly.
4 Place the filter back in the spout
area and push down to secure (C).
4